Setup guide square for Aeros single door

Here you will find a basic guide on how to assemble our square shower single sliding door shower series. NOTE: this is for frame assembly only, assembly of parts and accessories can be found on their respective model page…

Setup guide for Aeros square single door models.

Setup guide assembly procedure for square shower frame and base  

Step 1

Square single sliding door shower model.

Available in 3 sizes and is designed to stand in a corner

800*800*2090 ~ 2290 mm
900*900*2090 ~ 2290 mm
1000*1000*2090 ~ 2290 mm

Step 2

Square shower tray assembly.
Level the shower tray feet below the base and connect it to your waste pipe.

Step 3

Square shower tray assembly.

Level the shower tray feet below the base and connect it to your waste pipe.

Step 4

In this guide, the shower will be assembled with the door on the right-hand side.

• Place the bottom front door rail on the base where the front door will be located.
• Raise the clear side wall onto the base and insert the slot at the bottom of the front of the side wall onto the block at the end of the bottom door rail.

NOTE: If you assemble the door on the left, reverse the assembly process in the guide.

Step 5

Attach any accessories if the wall has them included.

Lock the rear panel to the side wall and rotate until it locks into position.

The bottom of the rear wall aluminum will slide under the aluminum on the base to lock into position.

Step 6

Attach accessories to the middle panel, connect to your water mains, and test for leaks from the hoses.

Lock the middle panel onto the rear wall and rotate until it locks into position.

Step 7

Attach any accessories if the wall has them included.

Lock the rear wall panel onto the middle panel and rotate until it locks into position.

The bottom of the rear walls will slide under the rails on the base to lock both into position.

Step 8

Attach the front aluminum vertical rail to the rear wall and rotate until it locks into position.

Slide the front aluminum down the rear wall and slide it over the bottom door rail block.

Step 9

Slide the top door rail over the front aluminum vertical rail and the side wall into the slots to lock into position.

The frame is now assembled.

Step 10

Attach the door handles to the door, the wide side will be on the inside, the narrow side will be outside.

Step 11

When attaching wheels on the door check that you have the top of the door in relation to your door entry.

Check by matching the magnetic strip on the door will match the magnetic strip on the frame.

• The top wheels are your level adjustment wheels.
• The bottom wheels are spring-loaded to insert into the bottom door rail.

NOTE: When screwing wheels into the door frame, we suggest using Loctite to ensure the bolts do not come loose over time.

Step 12

Once you have determined the top and bottom of the door and attached the wheels and added Loctite you can hang the door on the shower frame.

One top wheel on the front door rail and one top wheel on the side wall.

The bottom wheels will be inserted into the bottom rails by pulling the spring down so it inserts into the bottom rails

If the door needs adjustment (raising or lowering the door) you rotate the knurled nut on the top wheel to raise and lower the door.

When you are happy with the height and level, lock the small grub screw (top wheels) so it does not come loose over time.

Step 13

Attach the the cover plate on the side wall by inserting as shown in Fig 1 & 2

Insert the rubber splash strip on the edge of the door as shown

The shower comes with optional wall mounts. To use them attach one edge to the side of the walls that are against you bathroom wall and the other edge to the bathroom wall.

If you have any questions or require assistance regarding the setup guide for Aeros square single door models leave a comment below or use our customer service form from this link